Extension Configure/Manual Testcase 1

It is infeasible to test to ensure that every single configuration setting works properly, to do so would require a large amount of work, take a considerable amount of time, and never fully be able to ensure that every setting works. A lot of the code that renders the form and handles the input is shared between settings anyway, so simply testing "one of each" would provide an adequate testing solution for now.

1. Navigate to Special:Configure.
2. Ensure that you are able to navigate to each of the areas listed on the left hand side of the page.
3. Ensure that a change occurs when clicking on each of the arrows beside the name of each area.
4. Press the "Show changes" button.
5. Press the "Save settings" button.
6. Navigate to Special:Configure again.
7. Navigate to the Upload area.
8. Uncheck the first checkbox.
9. Check the second checkbox.
10. Remove as many entries from the first text box as required so they can all be seen at once.
11. Add one item to the second text box.
12. Delete one entry from the first key-value table.
13. Add one entry to the first key-value table.
14. Alter the value of the first single line text input.
15. Press the "Show changes" button.
16. Ensure that the changes you have made are listed, and that no changed you have not made are listed.
17. Check to see if you are returned to the same "section".
18. Press the "Save settings" button.
19. Navigate to Special:Configure again.
20. Click on the last item listed in the "old versions" box.
21. Ensure that the settings you changed are as they were before you changed them.
22. Press the "Save settings" button.
23. Navigate to Special:Configure again.
24. Ensure that the settings you changed are still as they were before you changed them.